Volvo 2009 S60 - Manual (Page 76)

02 Instruments and controls
Mirrors
02
76
To do so:
1. Switch the ignition to position II.
2. Press the button on the rear side of the
mirror with straightened paperclip or simi-
lar object for approximately 3 seconds until
ZONE is displayed.
> The number of the current magnetic
zone will also be displayed.
3. Press the button repeatedly until the num-
ber for the desired zone (1-15) is displayed.
After several seconds, the compass heading
will again be displayed, and the change of
magnetic zones is complete.
C A L Z O N E
C
A
L
Z
O
N
E
G026950
Calibrating the compass
Calibrating the compass
• Stop the car in a large, open area, away
from traffic.
• Turn off as many electrical devices in the
car as possible to avoid interference with
the compass (e.g. audio system, etc).
• Using a pen or similar object, hold the but-
ton (1) depressed for at least 6 seconds.
"
CAL " will be displayed.
• Drive slowly in a circle at a maximum speed
of 5 m.p.h. (8 km/h) until
CAL is no longer
displayed.
NOTE
This step can also be done by driving nor-
mally until CAL is no longer displayed.
Calibration is complete.
Power door mirrors
G029587
The mirror control switches are located on the
driver's door armrest.
Driver's side
Press the L switch (an LED in the switch will
light up) to activate the adjustment control and
then use this control to adjust the driver's door
mirror.
Passenger's door
Press the R switch (an LED in the switch will
light up) and then use the adjustment control
to adjust the passenger's door mirror.