Replacing components, Onboard tool kit, Wiper blades – Mini 2009 Cooper User Manual
Page 115: Lamps and bulbs
113
Replacing components
Onboard tool kit
Your vehicle comes with an onboard tool kit that
varies with the equipment version; it is stored
underneath the level load floor.
>
Mobility System with onboard tool kit and
tire change set
*
>
Tire change set with onboard tool kit for
space-saver spare tire
Wiper blades
Changing the front wiper blades
1.
Fold up the wiper arm.
2.
Position the wiper blade horizontally.
3.
Press the securing spring, arrow.
4.
Unhook the wiper blade toward the wind-
shield.
5.
Pull the wiper blade past the wiper arm
toward the top.
6.
Insert the new wiper blade.
7.
Press into position until you hear it engage.
To avoid damage, make sure that the
wiper arms are against the windshield
before you open the bonnet.
<
Changing the rear wiper blade
1.
Fold up the wiper arm.
2.
Rotate the wiper blade toward the back as
far as it will go, arrow.
3.
Press the wiper blade against the limit and
thus out of the mounting.
4.
Press the new wiper blade into the fixture
until it engages audibly.
Lamps and bulbs
Lamps and bulbs make an essential contribution
to vehicle safety. They should, therefore, be
handled carefully. The manufacturer of your
MINI recommends having your MINI Dealer per-
form any work that you do not feel competent to
perform yourself or that is not described here.
Never touch the glass of new bulbs with
your bare fingers, as even minute
amounts of contamination will burn into the
bulb's surface and reduce its service life. Use a
clean tissue, cloth or something similar, or hold
the bulb by its base.
<
You can obtain a selection of replacement bulbs
at your MINI Dealer.
When working on electrical systems, always
begin by switching off the consumer in
question, otherwise short circuits could result. To
avoid possible injury or equipment damage when
Online Edition for Part no. 01 41 2 601 123 - © 08/08 BMW AG