Mini 2004 Cooper - Manual (Page 50)

48
PARKING LAMPS/LOW BEAMS
Switching on the parking lamps
Turn to the first position. The front, rear
and side vehicle lighting is switched on.
Parking light on one side, refer to following
column.
Switching on the low beams
Turn to the second position. With the low
beams on and with the ignition switched
off, only the parking lamps will remain on.
'Follow me home' lamps
If you activate the headlamp flasher after
having switched off the engine and the
lights, the low beams will stay lit for a pre-
set period of time.
You can have this function set by
your MINI Dealer.
<
Standing lamps, left or right
For parking, you can activate lights on one
side of the vehicle. Observe local laws.
1. Turn the ignition key to position 0 or
remove the key
2. Switch on the low beams
3. Move the lever to the adequate turn sig-
nal indicator position.
'Lights on' warning
If the lights have not been switched off and
the ignition key is in position 0, an acoustic
signal sounds for a few seconds when you
open the driver's door to remind you that
the lights have not been switched off.
Daytime driving lamps*
If you desire, the light switch can be left in
position 2.
When the ignition is switched off, the car's
exterior lights go out.
The automatic headlamp range con-
trol for xenon lamps only operates
with the light switch in position 1 or 2. <
You can have the daytime driving
lamp function activated/deactivated
by your MINI Dealer. <
Online Edition for Part-No. 01 41 0 157 644 - © 09/03 BMW AG