Altera Cyclone V GX FPGA - Manual (Page 14)

4–4 Chapter 4: Development Board Setup
Factory Default Switch Settings
Cyclone V GX FPGA Development Kit October 2012 Altera Corporation
User Guide
f
For more information about the FPGA board settings, refer to the Cyclone V GX FPGA
Development Board Reference Manual .
3 PCIE_JTAG_EN
Switch 3 has the following options:
■ On (0) = Do not include the PCI Express Edge
connector in the JTAG chain.
■ Off (1) = Include the PCI Express Edge
connector in the JTAG chain.
On
4 — — —
Table 4–3. SW5 JTAG DIP Switch Settings (Part 2 of 2)
Switch
Board
Label
Function
Default
Position