Rs-232 cable – Altera DSP Development Kit, Stratix & Stratix Professional Edition Getting Started User Manual
Page 22
2–10
Development Kit Version 1.3.0
Altera Corporation
DSP Development Kit, Stratix & Stratix Professional Edition Getting Started User Guide December 2004
Connect the Cables to the Board & PC
Figure 2–2. Connect the ByteBlasterMV Cable to the EP1S25 or EP1S80 Board
RS-232 Cable
You can optionally attach the serial cable to one of the serial ports on your
PC and to the RS-232 male connector at J8 on the board. See
.
1
For the Stratix DSP board to communicate with the PC via the
RS-232 cable, RS-232 interface logic must be implemented in the
Altera device on the board.
For the EP1S25 development board, the J8 connector is located
on the bottom, right-hand side of the board. For the EP1S80
development board, the J8 connector is located on the bottom,
left-hand side of the board.