NISSAN 2011 Murano - Manual (Page 39)

Black plate (37,1)
Model "Z51-D" EDITED: 2010/ 7/ 23
SSS0232
Attaching rear center seat belt:
Always be sure the rear center seat belt
connector tongue and connector buckle are
attached. Disconnect only when folding down
the rear seat.
To connect the buckle:
1. Pull out the connector tongue from the
retractor base
*
1 .
2. Pull out the seat belt tongue from the
retractor base
*
2 .
3. Pull the seat belt and secure the connector
buckle until it clicks
*
3 .
The center seat belt connector tongue and
buckle are indicated by the
! and ~ mark.
The center seat belt connector tongue can be
attached only into the rear center seat belt
connector buckle.
To fasten the seat belt, see “Fastening the seat
belts” earlier in this section.
WARNING
. Do not unfasten the rear center seat
belt connector except when folding
down the rear seat.
. When attaching the rear center seat
belt connector, be certain that the
seatbacks are completely secured in
the latched position and the rear
center seat belt connector is com-
pletely secured.
. If the rear center seat belt connector
and the seatbacks are not secured
in the correct position, serious per-
sonal injury may result in an acci-
dent or sudden stop.
Safety — Seats, seat belts and supplemental restraint system 1-23