NISSAN 2008 Rogue - Manual (Page 245)

Black plate (252,1)
Model "S35-D" EDITED: 2007/ 7/ 3
SDI1480C
1. Remove the cell plugs
*
A .
2. Add distilled water up to the UPPER LEVEL
*
1 line.
If the side of the battery is not clear, check
the distilled water level by looking directly
above the cell; the condition
*
1 indicates
OK and the conditions
*
2 needs more to
be added.
3. Tighten cell plugs
*
A .
Vehicles operated in high temperatures or under
severe conditions require frequent checks of the
battery fluid level.
JUMP STARTING
If jump starting is necessary, see “JUMP
STARTING” in the “6. In case of emergency”
section. If the engine does not start by jump
starting, the battery may have to be replaced.
Contact a NISSAN dealer.
SDI2090
1. Alternator
2. Water pump
3. Drive belt auto-tensioner
4. Crankshaft pulley
5. Air conditioner compressor
WARNING
Be sure the ignition switch is in the OFF
or LOCK position before servicing drive
belts. The engine could rotate unex-
pectedly.
1. Visually inspect each belt for signs of
unusual wear, cuts, fraying or looseness. If
the belt is in poor condition or loose, have it
DRIVE BELTS
8-14 Maintenance and do-it-yourself