NISSAN 2008 Rogue User Manual

Page 46

Advertising
background image

Black plate (45,1)

Model "S35-D" EDITED: 2007/ 7/ 3

SSS0657

Rear facing — step 5

5. Remove any additional slack from the child

restraint; press downward and rearward
firmly in the center of the child restraint with
your hand to compress the vehicle seat
cushion and seatback while pulling up on
the seat belt.

SSS0658

Rear facing — step 6

6. Before placing the child in the child restraint,

hold the child restraint near the seat belt
path and use force to push the child restraint
from side to side, and tug it forward to make
sure that it is securely held in place. It should
not move more than 1 in (25 mm). If it does
move more than 1 in (25 mm), pull again on
the shoulder belt to further tighten the child
restraint. If you are unable to properly secure
the restraint, move the restraint to another
rear seating position and try again, or try a
different child restraint. Not all child re-
straints fit in all types of vehicles.

7. Check that the retractor is in the ALR mode

by trying to pull more seat belt out of the
retractor. If you cannot pull any more seat
belt webbing out of the retractor, the
retractor is in the ALR mode.

8. Check to make sure that the child restraint is

properly secured prior to each use. If the
belt is not locked, repeat steps 3 through 7.

After the child restraint is removed and the seat
belt fully retracted, the ALR mode (child restraint
mode) is canceled.

Safety — Seats, seat belts and supplemental restraint system

1-33

Advertising