Chenbro IP CAMERA 050862 - Manual (Page 20)

Chapter 4: Using Utility to Setup IP & Update Firmware
Fig.10. IP Configuration: IP Camera Advanced settings
i. Device Password
Use this to set an access password to the individual device. Once set, the user
must enter the password to access the device. In addition, the IP Address will
not be shown on the right display panel of Utility.
Devise
Password
not set.
Devise
Password
enabled. IP
Address
hidden.
Utility will request for the “Input Device Password” when you click either “Setup
Wizard”, “Launch IP Camera” or “IP Configuration”
iCAMView user manual -17-