Dolby Laboratories KDC-W8534 - Manual (Page 14)

14 | English
Sound Management system
1 Select the source to adjust
Press the [SRC] button.
2 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "S.M.S" is
displayed above the [2] button.
Refer to <Notes on Multi-function Key System>
(page 9).
3 Enter Sound Management mode
Press the [2] ("S.M.S") button.
• When "2 ZONE" of <Audio Setup> (page 12) is ON,
you cannot select "S.M.S".
4 Select the Sound Management item to
adjust
Press a [1] — [5] button.
Multi-function key operation Sound Management Item
[1] "CABIN" Cabin Setting
[2] "F" Speaker Select Front
[3] "R" Speaker Select Rear
[4] "SW" Speaker Select Subwoofer
[5] "Preset" [1] "RCL"
[2] "MEM" Recall mode
Memory mode
• "Preset": You can store an adjusted sound
management system value by selecting
"MEM". Refer to <Memory mode> (page 17).
Also, you can recall it by selecting "RCL". Refer
to <Memory Recall mode> (page 17).
5 Adjust the Sound Management item
Push the Control knob towards [ 4] or
[ ¢].
Each time you push the knob, the setting
alternates between the settings shown in the
table below.
Sound Managemnt Item Range
Cabin Setting OFF/ Compact/ Sedan/ Wagon1/
Wagon2/ Mini Van1/ MiniVan2/ SUV/
Passenger Van
Speaker Select Front 16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/ 6x9/
7x10/ O.E.M./ 10cm/ 13cm
Speaker Select Rear 16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/ 6x9/
7x10/ None/ O.E.M./ 10cm/ 13cm
Speaker Select Subwoofer 25cm/ 30cm/ 38cm over/ None/
16cm/ 20cm
6 Exit Sound Managemnt mode
Press the [6] ("RTN") button.
General features