Dolby Laboratories KDC-W8534 - Manual (Page 19)

English | 19
Display Type Selection
Changing the display mode.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [6] button.
Refer to <Notes on Multi-function Key System>
(page 9).
2 Enter display control mode
Press the [6] ("DISP") button.
3 Select the display mode
Press the [1] ("MODE") button.
4 Select the display Type
Push the Control knob towards [ 4] or
[ ¢].
Each time you push the knob, the display mode
alternates between the display modes shown in
the table below.
Display Mode Display
"Display Type A" 1
"Display Type B" 1
2
"Display Type C"
4 3
3
5
3 6
"Display Type D"
4 7
6
8 8 8 8 8 8
1 Graphic display part
2 Text display part
3 Text icon display part
4 Upper text display part
5 Middle text display part
6 Lower text display part
7 Source icon display part
8 Function item display
5 Exit display control mode
Press the [6] ("RTN") button.
• Under the display type other than "Display Type D",
the function item is not displayed. When you select
the display type other than "Display Type D", press [1]
to [6] buttons or [NEXT] button. The function item will
be displayed approximately 5 seconds.
• The indicator is displayed when the display type is set
to "Display Type C" or "Display Type D".
• Change the information by the Display Type. Refer to
the page on the following table for the methods to
alternate by the Display Type.
Display Type A B C D
Graphic 1 20 20 — —
Text 2 — 21 — —
Upper 4 — — 22 22
Middle 5 — — 23 —
Lower 6 — — 23 23