MIPRO mr801(2ce126)a2 - Manual (Page 5)

5. Caution
1. Grill: Protects cartridge and prevents " POP " noise.
2. Anti-Rolling Colored Ring: F or frequency identification. Its polygonal
shape also prevents the microphone from rolling when placed on a
flat surface.
3. Cartridge or microphone element/insert.
4. Housing: Upperportion is connected to capsule module. Internally, it
houses the transmitter PCB and battery compartment.
5. Battery Status Indicator: Indicates power on / off and the battery
status. When the power switch is turned ON, the red LEDs indicator
flashes briefly, indicating normal battery status. If no flash occurs, it
has either no battery or the battery is discharged or installed
incorrectly. If after power on the indicator stays lighted, it warns that
the battery is weak and should be replaced.
6. Power On-off Switch: Slide the switch for power" ON " or " OFF ".
7. Battery Compartment: Designed to accommodate one 9V battery.
8. Battery Cap: Covers the battery compartment.
(Fig.1)
1 3 2 6 5 4 8 7
The microphone is modular in design. (1) Grille (2) Anti-Rolling
Colored Ring (3) Cartridge (4) Housing (5) Battery Status Indicator (6)
PowerOn-Off Switch (7) Battery Compartment (8)BatteryCap. It also
incorporates "NoiseLock" dual-squelch circuitry to eliminate interference.
HANDHELD WIRELESS MICROPHONE
1. Parts Name And Functions
- 7 - - 8 -
1. Since the installation of antenna influences the operating efficiency of
the receiver, the most important rule is to minimized the distance
between receivingantenna and m icrophone a s short as possible for
betterreception and performance.
2. The external DC power supplyshouldnot be below 12V, otherwise it
would n o t work properly. If it is over 15V, some components of the
receiver will be damaged d u e to higher current. Use minimum 1A
power supply.
3. This system utilizes computer transformer. It is equipped w i t h 85 ~
265V switching power supply to avoid switching and it is not affected
by power instability.