Applied Motion PDO2035 - Manual (Page 3)

Mounting the Drive
You should mount the PDO 2035 on the heat transfer plate as shown below. Use #8
or #10 screws.
The amplifiers in the drive generate heat. Unless you are running at 1 amp or
below, you may need a heat sink. To operate the PDO 2035 continuously at maximum
power you must properly mount it on a heat sinking surface with a thermal constant
of no more than 4
°
C/watt. Often, the metal chassis or enclosure of your system will
work as an effective heat sink.
Features
Introduction
Thank you for selecting an Applied Motion Products motor control. We hope our
dedication to performance, quality and economy will make your motion control
project successful.
If there's anything we can do to improve our products or help you use them better,
please call or fax. We'd like to hear from you. Our phone number is (800) 525-
1609 or you can reach us by fax at (831) 761–6544.
-3- -14-
Built in 30 volt DC power supply. Drive accepts AC input, 110/220 V, 50/60Hz
Drives sizes 14 through 23 step motors. Can also be used to drive size 34
motors at low speeds.
Pulse width modulation, recirculating switching amplifiers
Phase current from 0.125 to 2.0 amps (switch selectable, 16 settings)
Step, direction, amplifier enable inputs, tach output, all optically isolated
Full and half step (switch selectable)
Automatic 50% idle current reduction (defeatable by internal jumper)
Built in ramping pulse generator with adjustable speed, accel, decel
Two speed ranges: 10 - 1200 Hz and 100 - 12000 Hz
Pluggable, screw terminal connectors
Fully enclosed in ventilated steel housing with aluminum heat transfer plate •
•
•
•
•
•
•
•
•
•
•
Optical
Isolators
step
external speed pot
direction
common
Step
Sequencer
Oscillator
current setting
full step/
half step
step
dir
accel
decel
speed adj
A+
A–
B+
B–
to
motor
Power
Supply
110/220
VAC
Amplifier
Block Diagram
!
Never use your drive in a space where there is no air flow
or where the ambient temperature exceeds 50˚C (120˚F)
Never block the vent holes.
Never put the drive where it can get wet.
Never allow metal particles near the drive.
2345
123
osc
options
1
enable
tach
out