Atlona HDMI - Manual (Page 6)

Quick Setup Guide
www.atlona.com · Toll-Free 1.877.536.3976 · International 408.962.0515 · Fax 408.743.5622
5
EDID:
Modes
Mode 0: 1080p - 2Ch audio
*3D and multichannel audio will not work in this mode*
Mode 1: 1080p - Multichannel audio
*3D will not work in this mode*
Mode 2: 1080p - 2Ch audio - 3D
*Multichannel audio will not pass in this mode*
Mode 3: 1080p - Multichannel audio - 3D
*The highest resolution the display and source are capable of will pass in this mode*
Mode 4: 1080p - Dolby Digital audio - 3D
*Only Dolby Digital and 2Ch will pass in this mode*
Mode 5: 1080i or 720p - 2ch audio
*Multichannel audio will not pass in this mode*
Mode 6: 1080p - EDID learning
*Learn the EDID of the display while in this mode. The EDID learn is non-volatile*
Mode 7: Software mode
*Read, save, and analyze EDID or update firmware with the included software in this mode*
Learn:
1. Connect the HDSync Display HDMI port to the displays HDMI port
2. Plug in the 5V DC power supply to the HDSync and wall
3. Turn on the display
4. Turn the HDSync rotary to mode 6
*Status LED will blink while learning the EDID*
5. When LED stops blinking, the EDID learn is complete. Leave the EDID rotary on mode 6
** To relearn or learn a different EDID, turn the rotary from mode 6 clockwise until it reaches mode 6 once more.
Repeat the above steps**
Software:
Read, save, or analyze EDID and update firmware from your computer using the included software. Easily
troubleshoot compatibility issues or verify what a device is capable of.
Setup:
1. Connect a 9-pin to 9-pin cable from the HDSync to your PC
2. Turn on your PC and HDSync
3. Insert the included software into your computers disc drive
4. Open the software file "HDMI EDID Recorder". For detailed instructions see HDSync instruction
manual (latest version)