Atlona AT UHD M2C BAL - Manual (Page 11)

11
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
RS-232
Connection
RS-232 is connected through a 3.5mm to 9-pin female D connector (DB9). The 3.5mm connector
pin out is pin 2 (tip/TX), pin 3 (ring/RX), and pin 5 (sleeve/ground).
Set Up
To set up the RS-232 hyperterminal (if not using 3rd party software) use the following steps:
1. Connect the M2C-BAL to a PC using a 9 pin to USB converter
2. Go to the Device Manager folder (see picture A).
3. Find the M2C-BAL COM port and right click with a mouse and select properties (see picture B)
NOTE: If unsure which COM port is the M2C-BAL, unplug the cable and plug it back in. It
will disappear and reappear on the COM port list.
4. Under the properties menu select the port settings tab and update the menu to the M2C-BAL
default settings of: Bits Per Second: 115200, Data Bits: 8, Parity: None, Stop Bits: 1 and Flow
Control: None. (see picture C)
Set up is done and any hyperterminal program may be used to control the M2C-BAL.
A B C