Atlona AT UHD M2C BAL - Manual (Page 7)

7
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
The home screen tab will
display the general system
information.
The network set up page will allow the IP information to be changed. When a change is made the
screen will grey and the ability to save or cancel will display at the bottom.
Note: When DHCP is on, the IP address cannot be configured. Turn DHCP off to enable IP configuration.
Note: For a stable connection when using a control system, it is best to set up a static IP. As you select an IP
address, make certain no other devices on your network are using that IP address.
Login Mode has been added to provide a secure telnet login. Once Login Mode has been turned on
a username and password will be required on all IP connections to the switcher.
Note: Login mode should be in off position when the M2C-BAL is used with control systems that do not
support passwords. If your control system supports password protection, you can turn login mode
on. The GUI always requires a password.
Note: The username and password used in IP Login Mode will be the same login information as the
WebGUI.