BIXOLON SRP-350plusIII - Manual (Page 23)

Rev. 1.03 - 23 -
SRP-350/352plusIII
2. Self-Test
The self-test checks whether the printer has any problems. If the printer does not function
properly, contact your dealer. The self-test procedure is as follows:
2-1 Make sure paper roll has been installed properly.
2-2 Turn on the power while holding down the FEED button and the self-test begins.
2-3 The self-test prints the current status of the printer including control ROM version and
the DIP switch settings.
2-4 After printing the current printer status, the printer wait for the next step after printing
the following lines. (The paper signal light keeps blinking.)
SELF-TEST PRINTING.
PLEASE PRESS THE FEED BUTTON.
2-5 Press the FEED button to continue printing. The printer prints a form using the built-in
character sets that can be printed.
2-6 The self-test ends automatically and the printer cuts the paper after printing the
following line.
*** COMPLETED ***
2-7 The printer is ready to receive data for normal operation upon completion of self-test
operation.