Casella CEL Multimet - Manual (Page 16)

Heater option: 24 V DC / AC, 82 Ω, 7 W
Connecting cable: 4.5 m without conduit
3.25 m with conduit
Note that the design of this sensor does not allow electrical adjustment.
Where the greatest accuracy is not demanded (better than ±2 o ), these
sensors can be interchanged.
However where higher accuracy is required, the setting up
procedure given in Appendix I can be followed.
5.3 Multimet Display
Power supply: 12 V DC
Power consumption: Approximately 250 mA
Display: 160 x 128 transflective graphics LCD with
CCFL backlight
Display units: mph, km/h, m/s, knots
Sensor polling: Approx. 5 readings per second
Processed data: Instantaneous value updated every second
2 and 10 minute rolling averages updated
every 5 seconds
2 and 10 minute maximum and minimum
values updated every 5 seconds
2 and 10 minute and 5 second direction
variation sector
Datalogging interval: 1 to 120 minutes
Memory capacity: 4500 readings
Logged data: Date,
time,
average maximum and minimum speed
and direction over logging period
Alarms: Instantaneous or 2 minute wind speed
Loss of sensor data
Dimensions: Panel mounting: 110 x 110 x 80 mm
Desk top enclosure: 125 x 125 x 133 mm
Mains Power Supply: Input: 90-260 V AC at less than 40 Watts
Output: 12 V DC 1.2 Amps
5.4 Applications
¤ Industrial emissions monitoring
¤ Wind monitoring at harbours, airports and helipads
¤ Wind monitoring for bridge management
¤ Nuisance dust monitoring for construction sites
¤ Landfill and waste management sites
¤ Sports events
Specifications
Page 16 of 16
MULTIMET Wind Speed and Direction System
& OnlinePro Software - Users Handbook