CONTA-CLIP EMS-Engraver - Manual (Page 7)

3.3 Installing the Engraving head
Please pay attention to inserting the engraving
head on both sides.The holding bar must be
parallel.
Press the engraving head down to its limit,
support the holding bar manually from the
bottom side in order to prevent damaging the
holding bar.
Secure the engraving head.
In order to prevent any movement of the engraving head during
the process, the safety lock needs to be closed by pushing to
the middle on both sides as shown.
Double check the proper mounting.
Install the support bearing.
Place the support bearing as shown,
snap in place.
Later the horizontal alignment of the engraving head
will be done by using the tool.
3.4 Arrange Vacuum cleaner (EVC) and Controller (EC)
Arrange the units behind the EMS-2, as shown.
6