CP Electronics MWS5 + slim line PSU - Manual (Page 4)

page 4
2. Dimensions & Mounting options cont.
Flush fitting the sensor head behind a diffuser
using the flange bracket
Flush fitting the sensor head through a panel
using the flange bracket
Flush fitting behind light fitting diffuser using the flange mount bracket
Glue the flange mount bracket on to the rear of the diffuser, and fasten the sensor head in place using the
two longer (19mm high) bracket clips.
Before gluing, please ensure that the glue used is compatible with both the acrylic flange mount bracket
and the diffuser material.
Flush fitting through gear tray or metal bulkhead using the flange mount bracket
Cut a 37.5mm diameter hole in the bulkhead plate (max. 1mm thick) to allow the front face of the sensor
head to pass through.
Glue the flange mount bracket on to the rear of the plate, and fasten the sensor head in place using the
two shorter (18mm high) bracket clips.