CP Electronics MWS5 + slim line PSU - Manual (Page 8)

page 8
Push button adjustment
Time, Lux and Sensitivity
Press and hold either button for at least 5 seconds then release: one of the LED‘s positioned behind
the lens will flash to show which function has been selected.
The LED will flash a number of times (between 1 and 7) to indicate the current setting (minimum =
1 flash, maximum = 7 flashes).
To change between Time (green), Lux (red) and Sensitivity (yellow) press and release the function
button until the required LED shows.
When the function has been selected press the adjustment button to increase the setting by 1 step.
Pressing the button after reaching 7 flashes will return the setting to 1 flash.
Time settings are as follows: 1 flash = 1 minute; 2 flashes = 5 min.; 3 flashes = 10 min.; 4 flashes =
15 min.; 5 flashes = 20 min.; 6 flashes = 25 min.; 7 flashes = 30 min.
Lux settings
MWS5 —1 flash turns on when very dark ; 7 flashes turns on regardless of ambient light.
-DD &-AD (Dimming) — 1 flash gives dim output level; 7 flashes gives maximum illuminance.
Sensitivity: 1 flash minimum; 7 flashes maximum.
After finishing adjustment, the LED will show the new setting 5 times and then return to operational
mode.
Default settings
Press and hold both buttons together: after 3 seconds the green LED lights. Release immediately to
restore the factory settings. Then isolate the supply, leave powered down for approximately 10
seconds and then re-power up the unit - the factory default settings will then be restored.
Programming handset adjustment
If programming is to be completed using the infra-red programming handset (Part No. DD-LCDHS)
please refer to section 5 (pages 9 and 10) for functionality, settings and programming parameters.
4. Setup cont.