CUE PEX - Manual (Page 23)

Fig. 18
Once you have confirmed by pressing Yes, ally adresses of ballasts are deleted (information about
groups remain saved) and a new assigning of addresses for a given set of ballasts is carried out.
Once everyvery founded ballast has its short address, a form for assigning ballasts into channels
(groups) is shown.
Fig. 19
There is a list of all found ballasts on the right side of the screen. The tube of the sellected ballast is
blinking for easy identification of the chosen light in the room. After you have locallised the light, you
can assign it into one ore more channels (groups) listed in the left part of the screen.. The blinking of
the tube can be stoped by pressing the “Fluor tube blinking” button. There are some other options
such as switching on all ballasts to the maximum by pressing the All on button, fading them to the
minimum by pressing Fade all or switching them off by pressing All off. to the m in a chosen group.
The same commands can be carried out for a whole group by pressing Group on, Fade group or
Group off. Reset ballasts resets all ballasts, while all ballast addresses as well as all grouping into
channels ale deleted. The Configurate button starts configuration of ballasts all over again. The Close
button ends the configuration and closes the configuration window.
User Manual PEX Software
www.cue.cz
Page 23 of 25