Datapath dL8 - Manual (Page 6)

6
Step 4
Operation Indicators
The front panel has three LEDs to indicate the operational status of the dL8:
• Power
• Input
• Status
Power
When illuminated, the Power LED indicates the dL8 is connected to a mains supply and the power switch
is on.
Input
When illuminated, the Input LED indicates a valid DVI source is connected.
Status
• Continuous illumination – Indicates the dL8 is operating normally.
• Flashing – Unit is operating over the normal operating temperature. Ensure the input fan vent is not
blocked.
When the dL8 device is connected to a PC by a USB cable, and the dL8 control application is active, then
all three lights flash in turn to help to identify which unit is being controlled.
EDID SETUP
The EDID SETUP button is used to populate the onboard EDID of the dL8 from the EDID on the device
connected to Output 1. When pressed, the three LEDs will flash in sequence to indicate that the operation
was successful.
If the LEDs do not flash, this indicates that the operation to copy the EDID did not work. This could be
because of either Output 1 does not have a device with an EDID or the EDID is corrupt and could not be
read.
Note: To avoid the accidental operation of the EDID SETUP, the button must be pressed for a mini-
mum of 3 seconds. The function will then be unavailable for a period of 10 seconds.