Future Automation LSM-FSE - Manual (Page 12)

In
st
al
la
ti
o
n
:
S
ta
ge
7
Page 11 of 20 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
LSM FSE/PSE EFA -
Lift System with FSE or PSE Mount & Electric Flap Actuator
Replacing the Covers & Mounting the Base Panel

If the FSE/PSE mechanism is
mounted in the lower position this
top cover plate is not required
BASE PANEL
BASE PANEL
BRACKETS
After the cables are routed through the the mechanism replace the covers. If the FSE/PSE
mechanism was lowered to the lower mounting position the top front cover is nor required
any more.
After the mechanism is in the correct position the next step is to lower the BASE PANEL into
place and fix from the underside through the BASE PANEL BRACKETS. A good tip is to
place the BASE PANEL in place and draw marks from the underside through the BASE
PANEL BRACKETS, then fix using a wood screw and a large penny washer, this will allow
you to adjust the position.