Pengo DT-5 - Manual (Page 14)

14 Two Speed (DT & RT) Series Manual
TYPICAL ATTACHMENT CONNECTIONS
Figure 3 Figure 4
Figure 5
EXCAVATOR / BACKHOE MOUNT
END OF BOOM (Figure 3)
Mounting Bracket connects directly to the boom with
the customer supplier connection pin. The Drive Unit
connects to the Mounting Bracket with the supplied
connection pin.
1 EXCAVATOR / BACKHOE MOUNT
QUICK COUPLER (Figure 4)
Mounting Bracket connects to the quick coupler when
the jaws of the quick coupler engage the pins on the
Mounting Bracket. The Link Arm connects to both the
Mounting Bracket and the Drive Unit with the supplied
connection pins.
2
SKID LOADER MOUNT
ATTACHMENT PLATE (Figure 5)
Attachment Plate connects to the mounting plate on
the front of the Skid Loader. The Link Arm connects
to both the Attachment Plate and the Drive Unit with
the supplier connection pins.
3
IMPORTANT: Before connecting the attachment to prime mover, inspect all mounting surfaces, attachment plates,
and quick couplers are free of dirt and debris. Ensure all attaching pins, fasteners and latches are properly secured.
Ensure that the mounting frame / attachment mounting plate is rigidly secured to the prime mover. Improper
installation can result in product damage, personal injury and death.
These three illustrations represent the three most
common attachment connections. Note the hydraulic
hoses are not shown in these illustrations.