Proceed DAP (non-CE) User Manual
Page 21
Advertising
21
(If you are uncertain as to how to prepare your remote control for learning
new commands, refer to the instructions provided with the remote control.)
5
REPEAT THE PROCESS OF “TEACHING” NEW COMMANDS TO THE VARI-
OUS BUTTONS ON THE DAP REMOTE CONTROL UNTIL ALL DESIRED
COMMANDS HAVE BEEN LEARNED BY THE REMOTE CONTROL.
If you take longer than approximately ten seconds between button pushes,
the DAP will time out and return to normal operation. If this occurs, return
to step #1 in this section.
6
WHEN FINISHED, RETURN TO NORMAL OPERATION BY ALLOWING THE
DAP TO “TIME OUT”
The DAP will “time-out” and return to normal operation after approximately
ten seconds.
Advertising