Thor Compact HDMI, YpbPr, Modulators + AC3 - Manual (Page 17)

H-AC3-CMOD-QAM-LL
17
12) RF On: User can choose to turn on or turn off the RF under this menu.
13) Bit Rate: User can read the current modulating bit rate and the maximum bit rate
14) TSID: (Transport Stream ID) User can view or adjust after enter this menu.
15) ONID: (Original Network ID)-User can view or adjust after enter this menu.
16) NIT: (Network Information Table)NIT table is a very important table for describing the
network and TS.User can enter the submenus displayed and edit the values or select the LCN
(Logical channel number) mode, and choose whether to insert the NIT. If user chooses to
insert the NIT, information (Network ID, Network Name, LCN Mode, Private Data and LCN
number of the program mentioned in explanation 6) will be added to the transport stream.
 NOTE: when the Private Data is set as 0*0, it is invalid.
17) VCT: Virtual Channel Table. This menu contains two sub-menus, Modulation Mode and
VCT Insert. User can edit modulation mode at the range of 0-255. Choose to insert the VCT
when J.83B is applied as the modulation standard.
18) EIT: EIT Insert - As mentioned above (6), the event information table can be chosen
whether to insert into the TS or not under this menu. If yes, the EIT information set above (6)
will be displayed on the TV screen. Language Code – to set the EIT language For example,
code of the English language is eng. If you set the code as eng, the EIT displayed will be in
English language.
19)-23) Please refer to Chapter 4 for details.
24) Save Config: Yes/No-to save/give up the adjustment of setting.
25) Load Saved CFG: Yes/No-to load/ not to load the saved configuration.
26)Factory Reset: Yes/No-choose/not choose the factory’s default configuration.
27) LCDTime out: A time limit that LCD will light off. Choose among 5s, 10s, 45s, 60s, 90s and
120s (seconds).
28) Key Password: to set a 6-digit password for unlocking the keyboard.
29) Lock Keyboard: Choose Yes to lock the keyboard, then the keyboard will be locked and
cannot beapplicable. It is required to input the password to unlock the key board. This
operation is one-off. (Password forgotten, please use the universal code“005599”.)