Toyotomi BS-35(F) - Manual (Page 9)

9
SECTION D:
OPERATION
FUELING
WARNING: Use KEROSENE only. Never use gasoline, thinner, benzene,
light oil or waste oil.
CAUTION: Make sure that the fuel is clean and free from dirt and water. Water and dirt may
cause combustion failure and shorten the life of components such as the fuel
pump. Be sure to refuel before the tank runs out. Avoid having the fuel tank
and fuel line run empty.
REMOVING AIR TRAP
When operating for the first time or when refueling an empty tank, air may be trapped in the
fuel line, making ignition difficult. In this situation, follow the procedures below:
1. Press “POWER SWITCH” to “OFF” position. Disconnect the
power supply cord.
2. Release the two (2) screws from the front panel and remove
the front panel.
3. To catch the fuel which will drain out, put a small container
under the strainer.
4. Loosen the screw on top of the strainer. Immediately wipe
off any spilled fuel.
5. Remove the trapped air thoroughly. Failure to remove all the air will cause improper ignition
and may extinguish the unit.
6. Tighten the screw after removing trapped air.
7. Plug into the receptacle. Press “POWER SWITCH” to “ON” position.
Note: In the event of an ignition failure, press “POWER SWITCH” to “OFF” position and
after 10 seconds press “POWER SWITCH” to “ON” position once again.
INSPECTION BEFORE OPERATION
1. Before turning on the POWER SWITCH, make sure that the water supply inlet is open and
that water runs out properly by opening a hot water faucet. If not, check the drain valve to
see if it has been left open.
2. Check for water leaks in the pipes.
3. Be sure there is a sufficient amount of fuel in the tank and that there are no leaks in the pipe
line.
4. Be sure the power supply is properly connected and grounded to the unit.
5. Be sure the area around the water heater is clear of flammable materials such as gasoline,
thinner or flammable vapors.
6. Be sure the exhaust pipes are securely connected and that there are no leaks.