Xtramus NuOutlet-LN V1.1 - Manual (Page 11)

11
Right
1. Outlet Power Supply – Plug in the power supply of the Device Under Test (DUT). The
power supply can be switched on and off either through switch or remotely across the
network.
2. Outlet Switch – Switches the outlet power on/off.
3. LED Lights
a) PWR – Green when the NuOutlet-LN has power.
b) SYS – Flashes green when the system is enabled.
Dark or Bright green means the system is abnormal.
c) Loading – Flashes green when a load is in the Outlet socket.
The higher the load, the faster the flashing.
d) Error –Bright yellow when there is a short circuit or an error occurs.
e) Outlet PWR –Bright green when the Outlet Power is on.
4. Reset button – Use a pointed object to reset the NuOutlet-LN to reboot the system with
the last saved configuration.
5. RJ45 10/100 Mb connector – Insert a category 5 cable into this socket.
a) Full – Bright orange when fully duplex.
b) Link/Act – Bright green when linked. Flashes green when transmitting and receiving
data.
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®