ZENNER MULTIDATA WR3 - Manual (Page 6)

6
Subject to modifications and errors excepted.
Any liability for misprints excluded. SAP120966_150622_EN
Installation instructions
Safety instructions
The installation has to be done by qualified per-
sonnel. Read the instructions carefully right up to
the end before starting to mount the device.
The current laws and regulations have to be
observed, especially EN 1434 part 1+6, (in Ger-
many also AGFW directive FW202 and DIN 4713
part 4 and the initial verification directive).
At devices with communication interfaces or
mains supply the general technical rules and the
correspondent regulations have to be followed.
While demounting flow sensors and temperature
sensors make sure no heating water escapes
from the pipe –
this can cause burns!
Close valves and release pressure before instal-
lation.
General Information
Take care of:
■
the display must readable at all times,
■
to avoid malfunctions due to other interfe-
rences do not install fluorescent lamps, switch
cabinets or electric devices such as motors or
pumps in the immediate vicinity of the meter
(minimum distance 1 m),
■
all welding must be finished,
■
the ambient temperature must not exceed
55°C,
■
the type of temperature sensor must corres-
pond with the calculator,
■
the pulse value of the flow sensor must corres-
pond with the one from the calculator.
The calculator has 7 screwed cable glands for
wires with a diameter between 4,2 and 10 mm.
Keep unused glands closed.
Mind the connection order: temperature sensors
first, flow sensor afterwards!
multidata is delivered ready for operation.
It does not need any settings or adjustings.
ZENNER International GmbH & Co. KG
Römerstadt 6
D-66121 Saarbrücken
Telephone +49 681 99 676-30
Telefax
+49 681 99 676-3100
E-Mail [email protected]
Internet www.zenner.com