Aervoe 1500-Watt Energy Center - Manual (Page 11)

11
1. Follow instructions provided with the wind turbine and set up as directed.
2. Turn the MAIN POWER SWITCH to the ON position. Charging the unit without it in the ON
position will cause inadequate charging.
3. Connect the user wired 3-phase AC POWER CONNECTOR & WIND TURBINE POWER CORD to
the WIND TURBINE INPUT on the Energy Center.
4. Follow the instructions for your turbine to start charging using wind power. Refer to Fig. 1 for
wind input status and the Wind & Solar Controller instructions.
5. Disconnect the turbine from the Energy Center once charging is complete or not in use.
Once charged, the Energy Center 1500 is ready to use. All power outputs may be used simultaneously
depending on the battery charge level and each does not exceed the maximum power limits listed in the
specifications section in this operating instruction manual. IMPORTANT: Check device specifications
first to make sure they are compatible with the 120V AC, 12V DC, of 5V USB voltage and amp (watt)
ratings of the Energy Center 1500. Failure to do so could damage your device.
120v AC Power Operation (Pure Sine wave Inverter)
The pure sine wave inverter provides the same stable 120V AC power as found in any home/office
electrical outlet and can safely power common AC appliances and devices rated up to 1500W with
1350W continuous operation.
1.
Make sure the Energy Center is at least 50% charged (12.5V). A fully charged unit will produce
optimum results (13.7 - 14V range).
2. Turn the MAIN POWER SWITCH to the ON position.
3. Turn the AC SWITCH to the ON position.
4. Connect your AC device to either of the 120V AC/15A outlets to operate.
5. During use the AC STATUS MONITOR will display volts and amps being used and the
WORKING LED will illuminate.
6. Monitor the Wind & Solar Controller (Fig. 1) during use. The available battery voltage will
appear in the display.
7. A 15A replaceable fuse is located above each 120V/15A outlet and protects against short circuit
and overload. Replace as needed with the same fuse specified in this manual.
Note: When the battery voltage is reduced below 10.7V the inverter will sound an alarm and
automatically shut-down. disconnect all AC devices and recharge the batteries using the
procedures described in the Charging section.
DC Power (12v or USb devices)
Operate devices or appliances from either of the two marine grade 12V DC 150W/15A outlets and/or
the two 5V/2A USB outlets.
1.
Make sure the Energy Center is at least 50% charged (12.5V). A fully charged unit will produce
optimum results (13.7-14V range).
2. Turn the MAIN POWER SWITCH to the ON position.
3. Turn the DC SWITCH to the ON position.
4. Connect your device to any of the 12V DC or 5V USB outlets.
5. Monitor the Wind & Solar Controller (Fig. 1) during use. Follow the Wind & Solar controller
instructions if needed.
6. A 15A replaceable fuse is located above the 12V DC outlet and protects against short circuit and
overload. Replace as needed with the same fuse specified in this manual.
Note: When the battery voltage is reduced below 10.7V an alarm will sound and all dC outputs
will automatically shut down. disconnect all dC devices and recharge the battery using the
procedures described in the Charging section.
POwER OUTPUT