Aervoe 1500-Watt Energy Center User Manual
Page 7
7
Symbols & Definitions
Wind Turbine
Battery Status - Full
When flashing the battery is overcharged and won’t
stop until the battery voltage recovers.
Day: Solar input & charge detected
Battery Status - Empty
When flashing the battery is over-discharged and
won’t stop until the battery voltage recovers.
Night: No solar input detected
Load status
Light Control - not available on the
#9680 Energy Center 1500
Normal load
Time Control - not available on the
#9680 Energy Center 1500
Load without output
When flashing indicates over-load. Remove load and
press Esc key to recover output.
Indicates a browsing feature is set.
Parameters (volt, watt, amp and load value).
Indicates the first load output or the second
load output. All loads should be in ON and
LOAD appear concurrently, and indicates the
output mode is constant on.
Activates the manual brake to the wind turbine and
stops rotation.
Programming Information
1.
The default screen will display as in Figure 1.
2.
The blue LCD backlight will come on and remain lit for 10 seconds unless a button is pushed.
3.
Press the (+) and (-) to cycle through the parameters
•
Wind Turbine Input Voltage = WIND 00.00 V
•
PV (solar) Input Voltage = PV 00.00 V
•
Wind Turbine Input Wattage = WIND 00.00 W
•
PV (solar) Input Wattage = PV 00.00 W
•
Wind Turbine Input Amps = WIND 00.00 A
•
PV (solar) Input Amps = PV 00.00 A
•
Load Output Current = LOAD 00.00 A and shows the current draw from your 12V or USB
device when connected to either of these DC outputs
•
Light Control & Time Control (not available on the #9680 Energy Center 100 and should be
kept at 0.0V
4.
Press the Enter button to save parameters and return back to the browsing window.
5.
Press the Esc button to return to the browsing window without saving a parameter. In the
browsing window, the Esc button is used as a manual reset key for load short-circuit or overload.
1 2