Aervoe 1500-Watt Energy Center - Manual (Page 8)

8
• LCD displays volt and amp status of the
inverter during use and when in standby.
• LEDs indicate when the battery is
charging, fully charged, if there is a
warning, or its working status (operating
a device).
Fig. 2
The AGM (absorbed glass mat) batteries are valve regulated, non-spillable, and deep cycle type. These
batteries offer long cycle life when charged and maintained according to these operating instructions.
ELECTRIC SHOCK - SHORT CIRCUIT & EXPLOSION HAZARD
GENERATES LETHAL VOLTAGE
• Only qualified persons with experience handling 12V batteries and power systems
should perform the removal and installation of this battery or fuse.
• Follow all instructions and be familiar with the important safeguards listed.
• Before removing the battery access panels, the user must make sure the MAIN
POWER SWITCH is in the OFF position.
• Remove all external power charging sources (AC, solar, or wind)
• Remove any devices connected to power outputs (120V AC, 12V DC or USB).
ENERGY CENTER 1500 #9680 (primary battery included):
•
12V/120Ah AGM battery installed in the Energy Center 1500 to charge and operate as outlined
• Includes a 12V DC interconnecting power terminal output used to connect the Energy Center
1500 and Energy Center Buddy together
ENERGY CENTER BuddY #9681 (secondary battery sold separately)
•
An additional 12V/120Ah AGM battery that connects to the Energy Center 1500 to increase
working capacity to 240Ah
• Includes 1 set of 12V battery charging cables that provide connection between the Energy Center
1500 and Energy Center Buddy through the interconnecting terminals
DANGER
AC STATUS MONITOR
working warning fully charged charging
AC STATUS MONITOR
bATTERy INFORMATION (INSTAllATION & SPECIAl PRECAUTIONS)