Dynex DX-32L200A12 - Manual (Page 19)

Using the remote control
15
DX-32L200A12/DX-37L200A12/DX-46L262A12
Connecting a basic home theater system
Using digital audio
To connect a basic home theater system using digital
audio:
1 Make sure that your TV’s power cord is unplugged
and the home theater system is turned off.
2 Connect a digital coaxial audio cable (not provided)
to COAXIAL (digital output) jack on the side of your
TV and to the digital coaxial audio jack on the digital
home theater system.
Using the remote control
Installing remote control batteries
To install the remote control batteries:
1 While pressing the cover release latch on the back of
the remote control, lift the cover off the remote
control.
2 Insert two AAA batteries into the battery
compartment. Make sure that you match the + and –
symbols on the batteries with the + and – symbols in
the battery compartment.
3 Replace the battery cover.
Aiming the remote control
To aim the remote control:
• Point the remote control towards the remote sensor
on the front of your TV.
Turning on your TV for the first
time
The first time you turn on your TV, the Setup Wizard opens.
The Setup Wizard guides you through setting up basic
settings including the menu language, date and time,
picture mode, and TV signal source.
To set up your TV:
1 Make sure that you have:
• Installed the remote control batteries. (See
page 15 for details).
• Connected an antenna, cable TV, or satellite TV.
(See page 8 to page 11 for details.)
• Connected the power cord. (See page 8 for
details.)
2 Press (Power), then wait several seconds. The
Choose Your Menu Language screen opens.
COAXIAL IN
Home theater system Digital audio cable
Side of TV
Cautions
• Batteries should not be exposed to excessive
heat, such as sunshine, heat registers, or fire.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery compartment
with a cloth. If chemicals touch your skin, wash
immediately.
• Make sure that batteries are disposed of
correctly. Do not burn or incinerate.
Notes
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• If the remote control is not going to be used for
an extended period of time, remove the
batteries.
Setup Wizard
Select Move EXIT Exit
Next
English
Fran ais ç
Español
Choose Your Menu Language
MENU Back
Set menu language to English, Fran ais, or Español. ç
DX-32L-37L-46L_11-1082_MAN_V2_EN.book Page 15 Tuesday, November 22, 2011 1:09 PM