DigiTech RP50 - Manual (Page 12)

Connecting a cable to the Input applies power to the RP50. Disconnecting your instrument
from the Input of the RP50 disconnects the battery power. Turn your amplifier(s) on and
adjust the volume(s) to a normal playing level. To prolong the battery life, disconnect your
instrument from the RP50’s Input when not in use .
AC Power
The RP50 can also be powered with the optional PS200R power supply. Connect the plug
of the PS200R power supply to the power jack on the rear panel of the RP50. Connect the
other end of the PS200R power supply to an AC outlet. Turn your amplifier(s) on and
adjust the volume(s)to a normal playing level.
About the RP50
The Presets
Presets are numbered locations of programmed sounds. Presets are recalled with the
Footswitches.The RP50 comes with 40 User Presets (Presets 1-40) and 40 Factory Presets
(Presets 41-80). The User Presets are locations where you may store presets you create.
The Factory Presets may not be saved over. From the factory, the 40 User Presets are
exact duplicates of the 40 Factory Presets. This lets you make your own presets without
the worry of losing any Factory Presets.
Play Mode
When you first apply power to the RP50, it powers up in Play mode. The far left LED lights,
indicating you’re in Play mode. In Play mode, use the Up and Down Footswitches to access
the presets.
8