AquaMAX EM50 Series - Manual (Page 18)

17
water supply in the event that this water heater was to become inoperable
for any reason. We recommend you provide advice to the system owner
about their needs and building backup redundancy into the hot water
supply system.
Water Heater Location
This water heater is suitable for either outdoor or indoor installation. The
water heater should be installed close to the most frequently used outlet
and its position chosen with safety and service in mind.
Sufficient and safe space for ease of service and access to heating unit,
thermostat, sacrificial anode and relief valve should be considered when
locating the water heater. The water heater must be installed upright in a
vertical position and must be accessible without the use of a ladder or
scaffold.
You must be able to read the information on the rating plate. If possible,
leave headroom of one water heater height so the anode can be inspected
and/or replaced. If adequate room is unavailable, the water heater must be
disconnected, drained and removed to enable servicing.
For outdoor installation, the water heater shall be installed freestanding on
a level and stable concrete base 50 mm thick.
For indoor installation or where property damage could occur, an overflow
tray and drain must be fitted in accordance with AS/NZS 3500.4. The drain
pipe from the tray should be periodically checked to ensure that it is not
blocked.
Do not install this water heater in a roof space as a mains pressure storage
water heater.
Note: Damage to the storage cylinder caused by incorrect installation is not
covered by warranty.