AquaMAX EM50 Series - Manual (Page 7)

6
To minimise scalding, especially for those people in high scald risk
categories i.e. young children, people with potentially incapacitating
medical conditions, elderly people etc, this water heater must be installed in
accordance with AS/NZS 3500.4.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
For early childhood centres, primary and secondary schools, nursing
homes or similar facilities for young, aged, sick or disabled persons, please
consult your local health authority for the correct temperature setting.
Turning On the Water Heater
Warning: The water heater can only be switched on upon completion
of the installation by a qualified person.
To turn on the water heater:
1.
Fully open the cold water isolation valve at the cold water inlet to the
water heater.
2. Switch on the circuit breaker or isolator marked “Hot Water” or “Water
Heater” at the switchboard.
Shut Down Procedure
If it is necessary to turn off the water heater:
1.
Switch off the circuit breaker or isolator marked “Hot Water” or “Water
Heater” at the switchboard or switch off the water heater isolating
switch if one is installed.
2. Close the cold water isolation valve at the cold water inlet to the water
heater.
Temperature Adjustment
The thermostat automatically controls the electricity supply to the heating
unit so that a constant temperature is maintained within the storage
cylinder. The thermostat is fully automatic and power is only used when the
water in the storage cylinder requires heating. There is no need to switch
the water heater off when it is not in use, except when you are going away
for an extended period.