Argox CP Series - Manual (Page 37)

37
Compact Printer Series - User
’s Manual
Control /
Indicator
Function
Power
Switch
 On: turns on normal operation (at
“I” position)
 Off: turns off power ( at
“O” position)
Note: Turn power off before connecting or
disconnecting cables
Power LED

It will start blinking while “Media Out”, “Media
Gap Not Found” or “Ribbon Out” has been
detected.
 Once printer cutter mode has been enabled,
when Cutter is jammed with paper or Cutter is
not installed, POWER indicator will blink.
 When RS-232 communication error is
detected, POWER indicator will blink.
Ready LED
 When printer is started, the READY indicator
will blink. In Ethernet model, the READY
indicator will blink for several seconds to wait
till Ethernet Card is ready.
 When printer receives data from host PC,
READY indicator will start blinking.
 READY indicator will blink when printing is
paused.

It will start blinking while “Media Out”, “Media
Gap Not Found” or “Ribbon Out” has been
detected.
 It will blink as soon as the printer module is