Artesyn ATCA-7365 Installation and Use (November 2014) - Manual (Page 241)

Supported IPMI Commands
ATCA-7365 Installation and Use (6806800K65N) 241
8.1.7.1.2 System Boot Options Parameter #97
This boot parameter is an Artesyn-specific OEM parameter. Its definition is given in the
following table.
8.1.7.1.3 System Boot Options Parameter #98
This boot parameter is an Artesyn-specific OEM parameter.
Table 8-10 System Boot Options Parameter #97
Data Byte Description
1 IPMC POST Type
Data 1 - Set Selector. This is the processor ID for which the boot option is to be
set.
2 Data 2 - IPMC POST Type Selector. This parameter is used to specify the IPMC
POST Type that the IPMC will execute.
0x00: Short POST
0x01: Long POST
0x02 to 0xFF: Not used
The System Boot Options parameter #97 is non-volatile. During blade production, its data is
initialized to 0xFF and its state is set to invalid. Its parameter data remains preserved after
IPMC power cycles and firmware upgrades.
The System Boot Options parameter #97 is only valid for IPMC.