Avalon Firestyles Hideaway E Fireplace - Manual (Page 5)

© 2010 Travis Industries Inc. 100-01183_000
Unpacking 5
Figure 4
Foam Block
Log Set
Site Selection and Preparation
! NOTE 1: A 15 Amp, 120 Volt circuit is required. A
dedicated circuit is preferred but not essential in all
cases. A dedicated circuit will be required if, after
installation, the circuit breaker trips or fuse blows on a
regular basis when the heater is operating. Additional
appliances on the same circuit may exceed the current
rating of the circuit breaker.
WARNING: Ensure the power cord is not installed so
that it is pinched or against a sharp edge and ensure
that the power cord is stored or secured to avoid tripping
or snagging to reduce the risk of fire, electric shock or
injury to persons.
Construction and electrical outlet wiring must comply
with local building codes and other applicable
regulations to reduce the risk of fire, electric shock and
injury to persons.
Do not attempt to wire your own new outlets or circuits.
To reduce the risk of fire, electric shock or injury to
persons, always use a licensed electrician.
This section provides instructions for selecting a location
and preparing the site to install the fireplace into your
surround.
Select a suitable location that is not susceptible to 1.
moisture and is away from drapes, furniture and high
traffic.
For ease of electrical hook up you may wish to locate the
2.
fireplace near an existing outlet (refer to NOTE 1).
Store the fireplace in a safe dry and dust free location.
3.
! NOTE: The dimensions of the fireplace are 20 ⅛ inches
(511 mm) wide x 33 ⅝ (854 mm) inches high x 9 ¾
inches (248 mm) deep. The viewing area is 17 ¼ inches
(438 mm) wide and 22 ⅓ (567 mm) inches high. The
fireplace does not require any additional venting.
Additional Items Required for Installation
This fireplace requires a Travis Industries (Avalon, Lopi,
or Fireplace Xtrordinair) face or trim kit to finalize the
installation. Do not operate this fireplace without the face or
trim.
For Bathroom Use
If this unit is installed in a bathroom it must be protected by
a GFI receptacle or circuit. If receptacle is used it must be
readily accessible.
To prevent electrical shock this unit is an electrical
appliance that is not watertight and must be installed as to
prevent water from entering unit. This must be installed
away from showers, tubs, etc. Never locate fireplace where
it may fall into a bathtub or other water container. High
temperatures may be generated under certain abnormal
conditions. Do not partially or fully cover or obstruct the
front of this heater.
5. Remove the Foam Block from within the firebox carefully,
supporting the chassis and/or Log Set as needed
(Figure 4).
NOTE: If using a liner, install it at this time (see page 18).
6. Follow steps 2 through 4 in reverse order to reassemble
the fireplace.
! NOTE: The model and serial number labels are located
under the Log Set. To access, follow steps 2 through 4
as described above to remove the Front Glass.
Pull the front edge of the Log Set up above the sheet
metal of the fireplace, then slide the rear edge of the Log
Set from underneath the mirror.