Avalon Firestyles Hideaway E Fireplace - Manual (Page 8)

8
© 2010 Travis Industries Inc. 100-01183_000
Fireplace Installation
Electric Fireplace Manual Control
The manual controls for the fireplace are located within
the storage box at the bottom of the unit (Figure 12). The
switches are accessible by opening the door on the bottom
of the trim.
3 Position Manual Control
Remote (right position): The unit is operated with the
supplied remote control.
Flame (center position): The flame effect is turned on.
Flame & Heat (left position): The flame effect and heater
are turned on simultaneously. When the manual control is
in the Flame & Heat position the heater does not run on the
remote operated thermostat.
! NOTE: When the manual control switch is in the Flame
and Flame & Heat positions, the fireplace unit will not
operate with the remote control.
Initialization Button
Used to synchronize the remote control.
USB Port
Use the USB port to charge your USB device. Charge time
will vary depending on the device connected.
! NOTE: The USB port is for charging only, it does not
provide input into the speaker system.
! NOTE: A retractable iPod™/iPhone™ USB charge
cable is included with the fireplace.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic switch will turn
Three nail down brackets are included with the fireplace to
secure the fireplace to the floor. These brackets are only
required when the front nailing brackets are not used. To
attach the brackets, remove the screws along the base of
the fireplace, install the brackets, and anchor the brackets
to the floor (see Figure 11).
Figure 11
Operation
Figure 12
Standby On/
Off Switch
Audio
Input
3 Position
Manual Control
Initialization
Button
USB
Port
Standby On/Off Switch
Places the unit in a Standby mode when not in use.
Audio Input
The Audio Input port is a 3.5 mm input jack which will allow
audio signals from MP3 players (or other devices) to be
played through the unit’s speaker system.
Nail Down
Bracket
Nail Down Bracket
Screws