Avalon Firestyles Cottage - Manual (Page 31)

Optional Equipment
31
Travis Industries 93508113 4 020325
Outside Air Boot Installation
(Part number 99200134)
The outside air boot routes outside air to the stove for combustion. Refer to the section "Outside Air
Requirements" on page 11 for installation concerns. The directions below detail installation.
1 Install the cover plate following the directions below.
2 Refer to the illustration below to
determine the location and size of the
hole penetrating the floor and. Cut the
hole prior to locating the stove.
3 Attach gasket to the bottom edge of the
lower air boot section (near the screen).
Attach gasket on top of the flanges on
the upper air boot section. Slide the two
sections together with both seams facing
the rear (do not attach the two sections
at this time).
4 With the legs installed, follow the
directions below for attaching the upper
section of the air boot (with gasket) to the
stove.
5 Slide the lower section down until it
contacts the hearth. Attach the two
sections together following the directions
below.
Detach the air intake
cover and cover plate
to expose the air
channel underneath
the firebox.
Phillips
Screwdriver
a
Install the 8” wide cover
plate included with the
outside air boot. It has a
clip to secure it to the
plate under the air contro
Replace the cover to
finalize installation.
b
NOTE:
When in place, the front of
the air boot is 8” in back of
the front edge of the stove
top.
Bottom of Stove
8-7/8”
5-1/8”
Attach the air boot with
the two screws included
with the kit.
1/4" Nutdriver
Attach gasket to the bottom
edge of the air boot.
Attach the included
gasket to all four top
edges of the air boot.
Use the included screws to attach
the two telescoping portions of air
boot together. The included drill bit
should be used to drill the hole.
Make sure the air boot is expanded
to the correct size before drilling.
5/16" Nutdriver 9/64” Drill Bit
Floor (and hearth)
The hole in the floor (and hearth)
must be a minimum 16 square
inches. It should be 1/2” smaller
than the footprint of the air boot in
each dimension to allow for the
gasket to seal.