Avery Dennison SNAP 500 - Manual (Page 13)

User’s Manual—SNAP™ 500 Gen 1 and Gen 2 13
Figure 2A: Shipping Carton
CAUTION: Do not discard any of the packing / shipping
material in case you have to move the printer to another
location or return it to AVERY DENNISON for service.
3. Shrink wrap protects the printer from the packing material and moisture.
4. Removing the printer from the carton requires 2 people.
5. Position your hands in the cardboard cutout as above. Carefully lift it out of
the box. Lift the printer from the bottom out of the lower foam packing and
place the printer on the workstation table.
6. Carefully remove the shrink wrap to avoid damaging the printer.
7. Turn the Stock Arbor knob counter-clockwise and remove the protective foam
behind the Stock Arbor.
8. Unpack the stacker from its box and place it on the workstation table next to
the printer. Refer to Section 2.5.1, Attaching the Stacker.
CAUTION: Lifting the printer from any component other
than case or stacker supports can damage the printer and
cause needless start up delays.