Avery Dennison SNAP 500 - Manual (Page 37)

User’s Manual—SNAP™ 500 Gen 1 and Gen 2 37
Test Pattern 2
1. Press and hold the Voice button for about two seconds: “Press Start for Test
Pattern.”
1. Press the Start / Stop button: “Press Start for Test Pattern 1.”
2. Press the Voice button: “Press Start for Test Pattern 2.”
3. Press the Start / Stop button: “Ready to Print Test Pattern 2. Returning to
Print Mode.” The Data light will turn on.
4. Press the Start / Stop button. The machine will begin printing Test Pattern 2.
5. To stop printing the test labels, press the Start / Stop button. The Data light
will remain on. Make any necessary adjustments, and press Start / Stop to
resume printing the test labels.
6. Once satisfied with the test label, press either the Start / Stop or Voice button
to stop the test run. The Data light will remain on.
7. Press and hold the Start / Stop and Voice buttons simultaneously to clear the
current batch of labels being printed.
8. The voice message will say, “Clearing Current Batch.” The Data light will go
out.
3.5.2 Setting / Adjusting Voice Button Volume
The volume level of the voice messages on your SNAP 500 printer is set at Level
3 at the factory. If you want to adjust the voice button’s volume setting on your
printer, follow the steps listed below.
NOTE: When you select volume setting, the menu will
begin with the current volume at which your machine is
set, Level 3.
1. Press and hold the Voice button longer than two seconds to activate the
Option Menu System: “Press Start for Test Pattern.”
2. Press the Voice button: “Press Start for Demos.”
3. Press the Voice button: “Press Start to Set Volume.”
4. Press the Start / Stop button: “Press Start for Volume Level 3.”
To increase from volume level 3 to 5, follow these additional steps.
5. Press the Voice button: “Press Start for Volume Level 4.”
6. Press the Voice button: “Press Start for Volume Level 5.”
7. Press the Start/Stop button: “Volume Set to Level 5. Returning to Print
Mode.”