Avery Dennison 6035 Programmer Manual Rev.A 7/98 User Manual
Page 133
7/9/98
ROM-DOS 6.22 Command Descriptions 3-75
L A S T D R I V E
CONFIG.SYS
Purpose
Set the maximum number of drives.
Syntax
LASTDRIVE = letter
Remarks
letter may be any character between A and Z. It stands for the last
drive letter that ROM-DOS can access. The default value for letter is
E.
The minimum number LASTDRIVE is the number of drives in your
computer. If letter is less than number of drives in your computer, then
the LASTDRIVE command is ignored.
LASTDRIVE is often used to cause ROM-DOS to make more space for
non-standard drives that are not in your system. These drives may be
CD-ROM drives, Flash disk drives, or network drives.
Example
LASTDRIVE = H
Sets H as the last drive ROM-DOS can access. If the computer has
five drives installed, there is room for three additional non-standard
drives.