Avery Dennison SNAP 500 Short Feed - Manual (Page 11)

581396-1.2.doc SNAP 500 Short Feed Addendum
Install Short Feed Nip Assembly
1. Install new nip assembly and secure with new, provided mount screws. Make sure short mount screw is installed on
the bottom of the assembly. This is to clear the new nip gear drive train. Install new 20T nip drive gear.
NEW NIP ASSEMBLY
LONG MOUNT SCREW
SHORT MOUNT SCREW
NEW 20T DRIVE GEAR
2. Install new nip gear drive train as shown below using the (2) kit provided 10-32 mount screws. Use existing knife
mount holes in frame to mount gear chain.
NEW NIP GEAR TRAIN
10-32 MOUNT SCREWS
EXISTING KNIFE
MOUNT HOLES