Awind WIGA / WGA-210 User's Manual - Manual (Page 31)

31
< Auto-Configuration Network Setup >
The default setting of the WPS box is DHCP client. When the WPS box is
connected to a LAN that already has a DHCP server present, the WPS box takes
an IP address assigned to it by the server. When the WPS box is connected to a
LAN that does not have a DHCP server, the WPS box becomes the DHCP server
in the network.
< IP Setup>
♦ You can select “obtain IP address automatically” or “Use the following
IP address”
♦ IP Address: The default value is 192.168.100.10.
♦ Subnet Mask: The default value is 255.255.255.0
♦ Default Gateway: The default value is 192.168.100.10
♦ DNS Server: The default value is 192.168.100.10
<DHCP Server Setup>
♦ You can select “auto(Enable/Disable DHCP Server” or “Disable”)
♦ Start IP: The start IP address of DHCP Server.
♦ End IP: The end IP address of DHCP Server
♦ Subnet Mask: The default value is 255.255.255.0
♦ Default Gateway: The default value is 192.168.100.10
♦ DNS Server: The default value is 192.168.100.10
< Wireless Setup>
♦ Wireless LAN: The default value is “Enable”.
Embedded AP SSID:SSID string ,max. Length is 32 bytes.
♦ Connect to Existing AP: This is “AP client” mode feature. By this
feature you can let you WPS device to join others Access Point via
wireless.
First, enter the existing AP SSID and required security key in “Existing
AP SSID” and “Key”, then reboot your system. After these steps, WPS
will connect to this AP by wireless automatically.
Note: The default value of AP client mode is “Disable”, also, LAN
function will be disabled during AP client mode.
♦ Region: default value is “Worldwide”.
♦ SSID Broadcast: The default value is “Enable”
♦ Channel: to set fixed channel or Auto. The “Auto” means after power
on WPS , it will scan all of wireless channel and select clear one channel
automatically.
♦ Encryption: you can select “Disable” or one of WEP/WPA/WPA2 64bit
or 128bit in ASCII or HEX string.
♦ Key: If Encryption is enabled, you have to set key value according to