Baby Lock Diana (BL480A) Getting to Know Guide - Manual (Page 11)

9
4
Place the thread from right and to left
into threading guide..
5 Place the thread from right to left
into threading guide.
6 7 8 & 9 Thread the balance of the
lower looper area of the machine following
the purple color-coded thread guides,
placing thread in guides.
10
& 11 Thread the looper eye (A) from front
to back. Pull about 10cm (4 inches) of
thread and position into V cutout (B) on
threader. Firmly hold thread tail with left
hand and pull threader lever (C) up to
place thread into correct position (D) for
sewing.
Note: Use tweezers provided in the
accessory case to aid in threading
the looper.
3 While holding thread with fingers, pass it
between the tension discs and pull thread
down to make certain it is properly located in
between the tension discs.