Baby Lock Diana (BL480A) Getting to Know Guide - Manual (Page 19)

17
4 &
5
Slip thread behind metal guide and
into center slot on thread guide.
6
Pass thread into the slot of take-up lever
cover.
7
Position thread into the center guide
located at base of take-up lever cover.
8 Slip thread from left to right into the thread
guide located on bottom of the needle
clamp. Position the thread into the center
section of the guide.
Note: Before threading eye of needle, make
sure thread is in front of thread guide located
on the bottom of the needle clamp, for cover
stitch and for chain stitch.
9 Thread the eye of the middle needle. Draw
about 10cm (4 inches) of thread through
needle eye to hang free. Place the thread
to the back, and slightly to left under the
presser foot.
Note: Use tweezers provided in the
accessory case to aid in threading
the needle.
3 While holding thread with fingers, pass it
between the tension discs and pull thread
down to make certain it is properly located in
between the tension discs.