BAFO BF-2043 User Manual
Page 18
USB 2.0 to IDE 2.5” hard disk Enclosure User’s Manual 17
1
1
1
1
23
23
23
23
Q:
After driver installed, there is no new hard disk model name show at “Disk
Drivers” of “Device Manager” or “Universal Serial Bus controllers” does not
have “USB Mass Storage Device” appear.
A:
Adjust jumper of hard disk to “Cable Select” or other setting and try again.
Q:
If a brand new hard disk has been installed at enclosure. It shows “USB Mass
Storage Device” in “Universal Serial Bus controllers”, but there is not any new
hard disk at “Disk drivers”.
A:
Please
FDISK
and
FORMAT
hard disk.
Q:
When transferring file and system hang-up.
A:
Set “Never” at “Turn Off hard disk” of “Power Management” of “Device Manager”.
Q:
When I connect the PS/2 to DC cable (USB to DC cable) to the enclosure, it
cannot works.
A:
It might be the problem of your computer cannot provide the enough current to
start up the hard disk. You have to connect the power adaptor.
Q:
How can I choose the power adapter and know it is the right spec for this
enclosure.
A:
The power adaptor specification is DC Output 5V, 2.5A and the connector must
be the same as the picture below.
* Please unplug the power adaptor when the enclosure is not use.
4
4
4
4
)
)
)
)
Information in this document is subject to change without notice. The manufacturer
does not make any representations or warranties (implied or otherwise) regarding the
accuracy and completeness of this document and shall in no event be liable for any
loss of profit or any other commercial damage, including but not limited to special,
incidental, consequential, or other damages.
No part of this document may be reproduced or transmitted in any form by any means,
electronic or mechanical, including photocopying, recording or information recording
and retrieval systems without the express written permission of the manufacturer.
All brand names and product names used in this document are trademarks, or
registered trademarks of their respective holders.